Skip to content
CFM Limited logo

Compliance

How often should your vehicles have a safety inspection?

3 min read

Your safety inspection interval is declared on your operator's licence, and DVSA expects it to reflect how the vehicle is actually used rather than how often it is convenient to book it in. Get that wrong and it is one of the first things a traffic examiner will pick up.

Where the interval comes from

When you applied for your O-licence you told the traffic commissioner how often each vehicle and trailer would be inspected. That figure is a promise. DVSA's Guide to Maintaining Roadworthiness is the reference every examiner works from, and it sets out suggested starting points based on the kind of work the vehicle does.

Type of operationSuggested interval
Lightly loaded vehicles, easy operating conditions10–13 weeks
General haulage, trunking6–10 weeks
Arduous work, constant heavy loads4–6 weeks
Off-road, difficult conditions4 weeks
Any vehicle or trailer 12 years or older6 weeks

These are a guide, not a rule. The obligation is that the interval suits the vehicle, and the responsibility for judging that sits with you as the operator.

Time, not mileage

If you schedule inspections by mileage, you still have to enter an equivalent time-based maximum on the Vehicle Operator Licensing system, and that maximum cannot exceed 13 weeks. A vehicle that happens to do very few miles in a quarter still needs looking at.

This catches people out with seasonal work. A tipper that sits for eight weeks in winter has not stopped ageing — brakes seize, tyres go flat-spotted, and corrosion carries on regardless.

Plan six months ahead

The Guide is specific about this: inspection dates should be identified at least six months in advance on a planner, wall chart or scheduling system. There are two good reasons for it beyond the fact that DVSA asks.

  • Workshop availability. If you only discover a PMI is due next week, you are booking into whatever slot is left rather than the one that suits your operation.
  • It shows intent. A planner is evidence that maintenance is being managed rather than reacted to, and that counts at a maintenance investigation.

When to shorten the interval

An interval that was right when the vehicle was new may not be right now. It is worth reviewing when any of these change:

  • The vehicle passes its tenth year, and again at twelve
  • The work changes — general haulage to tipper work, or on-road to site work
  • Inspections start turning up the same defect repeatedly
  • Drivers are reporting more defects than they used to
  • The vehicle has had an annual test failure or a roadside prohibition

Shortening an interval is straightforward and reflects well on you. Running to an interval that no longer fits the work does not.

What a PMI at CFM includes

We carry out safety inspections on light commercials, rigids, tractor units, trailers and PSVs. Every inspection is metered on our roller brake tester, laden where it needs to be — we hold a loaded trailer and have an on-site loading facility for exactly that. There is more on why that matters in our post on brake performance testing at every safety inspection.

Anything found is quoted and put right in the workshop, and you get a completed, signed inspection sheet for your maintenance file.

Book in at Keighley

CFM runs a two-lane DVSA Authorised Testing Facility, a DVSA-approved tachograph centre and an IRTE-accredited workshop at Parkside Works, Parkwood Street, Keighley BD21 4PJ. We are open 07:00–17:00 Monday to Friday and 07:00–12:00 on Saturday, and we cover Airedale, Bradford, Wharfedale, Craven and Leeds.

Call 01535 662706 or send us an enquiry — tell us the vehicle and what you need, and we will confirm the earliest available slot.

Vehicle off the road? Let's get it moving.

Call the workshop or send us the details. We'll give you a clear quote and the earliest slot we can.

Call now Get a quote